6.1.14.4. Carburetor 2E3
Carburetor 2E3 top view
|
|
1 – steam separator,
2 – gate cover,
3 – block of movement of the gate,
4 – fuel supply hose,
5 – thermotime valve,
6 – vacuum chamber of a secondary butterfly valve |
Automatic air gate of the carburetor 2E3
Arrangement of the accelerating pump and block of movement of the gate of the carburetor 2E3
|
|
1 – accelerating pump,
2 – block of movement of the gate |
Arrangement of the valve of enrichment of partial loading and cam of the drive of the accelerating pump of the carburetor 2E3
|
|
1 – valve of enrichment of partial loading,
2 – кулачкок drive of the accelerating pump |
| PERFORMANCE ORDER |
| 1. Remove the carburetor from the car, then merge fuel from a separator of steam and the float-operated camera. Clear the carburetor outside. |
| 2. Mark and disconnect hoses and electric sockets from the carburetor. |
| 3. For access to jets and the float-operated camera unscrew five screws and remove the top part of the carburetor. Blow jets and channels of the carburetor compressed air. For removal of jets unscrew them. |
|
4. Take the fuel filter from an union opening for what use an edge of the thin screw-driver and screw in in the filter the screw with the M3 carving on depth of 5 mm. |
| 5. Clear a deposit and dirt from the float-operated camera. Check a condition of the needle valve and with wear or defects replace it. |
| 6. Check a condition of a float and in the presence on it cracks or other defects replace it. |
| 7. Adjustment of provision of a float is not provided. Check that the needle valve was closed before achievement by a float of the top situation. |
| 8. Check a state and, if necessary, replace diaphragms in the device of enrichment of partial loading and in the accelerating pump. |
| 9. Further dismantling of the carburetor is not recommended. |
| 10. Assembly is made in the sequence, the return dismantling. At assembly of the carburetor use new laying and sealing rings. Grease drafts with lubricant on the basis of a molybdenum disulfide. |
|
11. Before installation execute checks and adjustments of the carburetor.
|
|
