85425ea0




6.1.16. Removal and installation of a final collector

Removal

PERFORMANCE ORDER
Models of 1,2 l
1. Lift and fix a forward part of the car on supports.
2. Working under the car, disconnect a reception exhaust pipe from a final collector for what unscrew two bolts and remove springs.
3. Remove the air filter.
4. Unscrew six bolts fixing a final collector to a head of the block of cylinders and remove a collector and laying of a collector.
L models 1,3, 1,4 and 1,6
5. Remove the air filter. Remove an air inlet of the air which is warmed up by a final collector.
6. Unscrew nuts or bolts and disconnect a reception exhaust pipe from a final collector.
7. Unscrew nuts of fastening of a final collector and remove a collector from hairpins. Remove laying of a final collector.

Installation

PERFORMANCE ORDER
Models of 1,2 l
1. Installation is made in the sequence, the return to removal, but at the same time it is necessary to use new laying. You make tightening of bolts of fastening of a collector gradually and evenly, since the middle to edges.
L models 1,3, 1,4 and 1,6
2. Installation is made in the sequence, the return to removal, but at the same time it is necessary to use new laying. Tighten nuts of fastening of a collector gradually and consistently, beginning from the center to edge. At connection of a reception exhaust pipe to a final collector use new laying.