85425ea0 Gap of the air gate

1. Start the engine and warm up it up to the normal working temperature, then switch off the engine and remove the air filter.
2. Extend the handle of control of the air gate against the stop and check that draft turned in completely closed position against the stop of the lever. If necessary adjust a cable of control of the air gate.
3. With the air gate which is completely extended by the handle of management start the engine and check that between the air gate and the diffuser it is possible to insert a drill shaft diameter specified in subsection 6.1.1.
4. If necessary weaken a lock-nut and, rotating the adjusting screw (is specified by an arrow) located over the vacuum chamber adjust a gap.
5. Switch off the engine, tighten a lock-nut and install the air filter.