13.24.5. Replacement of switches
Prevention
Before removal of any switch remove a weight wire from the accumulator.
LIGHTING SWITCH
| PERFORMANCE ORDER |
|
1. The screw-driver wring out the fixing brackets located from switch sides and take the switch from the panel (the spring clamp is noted by an arrow). |
| 2. Disconnect the electric socket from the switch. |
| 3. If the switch is not removed, remove the dashboard. |
| 4. For installation of the switch connect to it the electric socket and install the switch into place before accurate fixing. |
|
SWITCH OF THE LIGHT ALARM SYSTEM
The switch acts and installed in the same way, as well as the lighting switch
(see above).
SWITCH OF FOG LIGHTS
| PERFORMANCE ORDER |
|
1. Using a screw-driver edge as the lever, take the switch from a nest, then disconnect from it the electric socket and remove it. |
| 2. Installation is made in the sequence, the return to removal. |
|
REGULATOR OF LIGHTING OF THE DASHBOARD
| PERFORMANCE ORDER |
| 1. Remove the dashboard. |
|
2. Unscrew the screw and remove the regulator of lighting of the dashboard. |
| 3. Installation is made in the sequence, the return to removal. |
|
SWITCH OF THE FAN OF THE HEATER / HEATER OF BACK GLASS
| PERFORMANCE ORDER |
| 1. Removal and installation of the switch is made in the same way, as well as the lighting switch (see above). |
| 2. If the switch is not removed, remove the dashboard. |
|
SWITCHES ON THE STEERING COLUMN
| PERFORMANCE ORDER |
| 1. For improvement of access to switches it is desirable to remove a steering wheel. |
| 2. Unscrew screws and remove the top and lower casings of a steering column. Casings of a steering column fasten 8 screws on the steering column regulated on height and 5 screws on an unregulated steering column. |
|
3. Release spring clamps and remove switches from a steering column. |
|
4. If necessary unscrew two screws and remove a casing of switches. |
| 5. Installation is made in the sequence, the return to removal. |
|
IGNITION LOCK
See subsection 12.17.
STOPLIGHT SWITCH
| PERFORMANCE ORDER |
| 1. Disconnect electric sockets from the switch and, having turned the switch on 90 °, remove it from an arm. |
| 2. Before installation of the switch of stoplights take a plunger from the switch on the maximum distance for automatic adjustment of the switch. |
|
THE MIRROR SWITCH WITH THE ELECTRIC DRIVE
| PERFORMANCE ORDER |
| 1. Remove a back part of the central console. |
| 2. Release and remove the switch. |
| 3. Installation is made in the sequence, the return to removal. |
|
SWITCH OF WINDOW REGULATORS
Removal and installation of the switch is made in the same way, as well as the mirror switch with the electric drive (see above).
SWITCHES OF ILLUMINATION OF SALON
|
|
Switches of illumination of salon of plunger type are installed in door racks (the arrow specified the switch of lighting of the luggage compartment). |
The same switches operate lighting of the luggage compartment and a ware box.
| PERFORMANCE ORDER |
|
1. Open a door, unscrew the screw of fastening of the switch and take it from a door rack. |
| 2. Tie to the wires going to the switch, a cord. |
| 3. Disconnect the electric socket from the switch. |
| 4. Installation is made in the sequence, the return to removal. |
|
