13.24.22. Removal and installation of the radio receiver with the player of cartridges
On cars the radio receiver or the radio receiver with the player of cartridges serially is installed.
EARLY MODELS
| PERFORMANCE ORDER |
| 1. Insert two special brackets on the right and at the left into openings of the forward panel of the radio receiver. |
| 2. Slightly wring out brackets outside at the expense of what clamps of brackets will nestle inside. |
|
3. In this situation take the radio receiver by uniform effort. |
|
4. Disconnect electric sockets and the plug of the antenna from the radio receiver. |
|
5. If necessary unbend uvulas and take a radio receiver pocket. |
| 6. At installation of the radio receiver connect to it electric sockets and the plug of the antenna and insert the radio receiver into place to a zashchelkivaniye of clamps. |
|
LATE MODELS
Since 1989 for prevention of theft of the radio receiver the following measures are provided:
– openings for installation of brackets for removal of the radio receiver are closed by screws;
– registration number of the radio receiver is beaten out on a casing;
– on all models the electronic code of safety is established. After an accumulator detachment the radio receiver will not work until the corresponding code is entered into the receiver.
| PERFORMANCE ORDER |
|
1. Unscrew cap screws from four openings on radio receiver corners. |
| 2. Further operations on removal and installation of the radio receiver are similar to operations on removal and installation of the radio receiver on early models (see above). |
|
