13.24.15.1. Replacement of the making components
THE SWITCH ON THE DRIVER'S DOOR
| PERFORMANCE ORDER |
| 1. Remove a door upholstery. |
| 2. Remove from a door a protective film about the switch. |
| 3. Unscrew two screws, disconnect the electric socket of the switch and disconnect the switch from the driving lever of the lock. |
| 4. Remove the switch. |
| 5. Installation is made in the sequence, the return to removal. |
| 6. If necessary replace rubber pillows of the switch. |
|
SERVOMOTOR OF THE PASSENGER AND BACK DOOR
Replacement of the switch is made similarly, as well as replacement of the switch by the driver's doors (see above).
TRUNK LID SERVOMOTOR ON MODELS THE SEDAN
| PERFORMANCE ORDER |
|
1. Open a trunk lid and remove from it plastic finishing. |
|
2. Unscrew two nuts, the fixing mechanisms of a latch and two screws fixing a servomotor (1 – nuts of fastening of a latch of a trunk lid, 2 – servomotor screws, 3 – draft). |
| 3. Remove a servomotor from a latch and disconnect from it the electric socket. |
| 4. Installation is made in the sequence, the return to removal. |
|
CONTROL UNIT
| PERFORMANCE ORDER |
| 1. Remove the finishing panel in deepening for legs of the forward passenger. |
| 2. On models with system of injection of fuel unscrew and move the control unit of system of injection of fuel together with an arm aside. |
| 3. Unscrew the screw of fastening of an arm of the control unit. |
| 4. Remove the control unit together with an arm, then disconnect from it the electric socket and unscrew an arm. |
| 5. Installation is made in the sequence, the return to removal. |
|
