| 1. Remove a head of the block of cylinders, the oil pallet and the oil pump. |
| 2. New covers of rods are not marked therefore check existence on them of tags and, at their absence, put them, beginning numbering from the drive. |
| 3. Unscrew bolts of fastening of covers of rods and arrange them so that at installation they got up on the places. |
| 4. Uncover rods rods. |
| 5. If necessary take connecting rods from a cover of a rod and a rod. Have inserts so that at installation they rose on the places. |
| 6. Pistons with rods need to be taken through the top part of the engine, pushing out them the hammer handle. If there is a deposit in the top part of the cylinder, remove it with a scraper from soft material. Existence of a step in the top part of the cylinder testifies to excessive wear of the cylinder and need of boring of cylinders of the engine. |
| 7. It is not recommended without need to separate pistons from rods. Because the piston finger is pressed in a rod, its removal and installation requires use of the special equipment. |
| 8. If pistons need to be removed from rods, apply on the tag pistons located from the same party, as a tag on a rod. |
