85425ea0




4.1.14. Removal and installation of a back sealing ring of a bent shaft

Removal

PERFORMANCE ORDER
1. Remove the engine from the car, then remove the oil pallet and a flywheel.
2. Weaken bolts of fastening of a back cover of a bent shaft and take a back sealing ring of a bent shaft.

Installation

PERFORMANCE ORDER
1. Grease working edges of a new sealing ring of a bent shaft and, being careful, establish it into place so that it was aflush with a back cover of a bent shaft.
2. Apply a thin film of sealant on the interfaced surfaces of a back cover of a bent shaft and tighten bolts of fastening of a cover the required moment.
3. Install the oil pallet and a flywheel and then install the engine in the car.