4.1.12. Removal and installation of support of the power unit


1. The power unit leans on three support. One on the right side supports the engine, one on the left side supports the transmission and the third in the center supports a back part of the power unit.
2. For removal of a support of the engine or the transmission establish a jack about the corresponding support and raise so that the weight of the power unit was perceived by a jack.
3. Unscrew the bolts fixing a support of the power unit to the engine or the transmission and a body and remove a support with the corresponding rubber pillow.
4. For removal of a back support lift a forward part of the car and fix on supports.
5. Support the power unit under differential a jack through wooden whetstone.
6. Unscrew two bolts fixing a support to the body bottom, and unscrew the nut and a bolt fixing a rubber pillow to a support. Moving a rubber pillow back, remove it from a support and take from under the car.


1. Installation is made in the sequence, the return to removal. Tighten bolts of fastening of support of the power unit the required moment. Clear carving openings for bolts the corresponding tap. Before a vvinchivaniye of bolts apply the means interfering unscrewing of bolts on a carving of bolts.
2. If on a back support there is an arrow, then at installation of the shooter has to be directed forward.