85425ea0




3.1.3.1. Each 15 000 km

Periodic replacement of oil and oil filter – the most important preventive procedure of maintenance. When engine oil grows old, it becomes liquid and polluted that leads to premature wear of the engine.

Before this procedure gather all necessary tools and materials. It is necessary that the engine was warm in order that oil flew down together with the bulk of the substances polluting it better.

PERFORMANCE ORDER
1. Uncover a maslozalivny mouth.
2. Weaken a drain stopper approximately on a half of a turn. Place a container for discharge of oil under a drain stopper and unscrew a stopper completely. If it is necessary, press a stopper when you unscrew that oil did not proceed prematurely.
3. When oil completely flows down, move a container under an oil filter.
4. Check a condition of ring consolidation of a masloslivny stopper. Wipe everything around a drain opening a rag and reliably screw up a masloslivny stopper into place.
5. Use the special tool to weaken an oil filter, then unscrew it a hand.
6. Wipe all traces of oil and dirt around the place of fastening of the filter. Check whether there was no rubber consolidation on the block of cylinders. If it remained, then remove it.
7. Grease with a thin layer of engine oil rubber consolidation of a new oil filter and screw up the filter a hand, without using any tools.
8. Establish a wheel and lower the car on the earth.
9. Fill in oil in the engine, using the corresponding grade of oil. Fill in a half of necessary amount of oil and wait several minutes that oil flew down in the pallet, then continue to fill in oil in the small portions until the level of oil reaches the minimum level on the probe. At addition about one more liters the level of oil will rise to maximum on the probe. Close a cover of a jellied mouth.
10. Start the engine and let's it work several minutes. Check it regarding leak of oil around the filter and a drain stopper on the pallet. Keep in mind that the control bulb of pressure of oil can burn several seconds as oil has to fill all channels and oil capacities in the engine.
11. Switch off the engine and wait several minutes that oil flew down in the pallet. Check the level of oil and add if it is necessary.