12.8. Replacement of the back shock-absorber
Top fastening of the back shock-absorber
|
|
And – without system of a self-regulating back suspension bracket,
In – with system of a self-regulating back suspension bracket or with two lock-nuts,
X = 9 mm,
Y = 6 mm
|
Prevention
Removal of shock-absorbers needs to be made in turn. You make replacement of shock-absorbers in pairs on one axis of the car.
SEDAN AND HATCHBACK
| PERFORMANCE ORDER |
| 1. Working in the luggage compartment, uncover, closing the top fastening of the shock-absorber. |
|
2. Unscrew a nut of the top fastening of the shock-absorber, at the same time hold a shock-absorber rod from a provorachivaniye the second wrench. Remove a washer and a rubber element of the top fastening of the shock-absorber. |
| 3. Lift a back part of the car and fix on supports. |
| 4. In the presence, working under a back part of the car, disconnect the air duct of system of the self-leveled back suspension bracket from the shock-absorber. |
|
5. Support by a jack the corresponding lever of a back suspension bracket. Unscrew the bolt (is specified by an arrow) fixing the lower part of the shock-absorber to the longitudinal lever of a back suspension bracket. |
| 6. Manually squeeze the shock-absorber and take it from the longitudinal lever of a back suspension bracket. |
| 7. Take the shock-absorber from under the car and remove a rubber element of the lower fastening of the shock-absorber and a cup from the top part of the shock-absorber. |
| 8. Using a kiyanka, establish the lower fastening of the shock-absorber in an arm. |
| 9. Screw in a bolt of the lower fastening of the shock-absorber and tighten it the required moment. |
| 10. Partially lower the car, at the same time establish the top fastening of the shock-absorber into place. |
| 11. Lower the car on the earth, then establish a rubber pillow and a washer of the top fastening of a rod of the shock-absorber. |
| 13. Tighten a nut of fastening of a rod of the shock-absorber so that the rod of the shock-absorber acted, as shown in rice. Top fastening of the back shock-absorber. |
| 14. Establish a cover. |
| 15. Similarly replace the second back shock-absorber. |
| 16. On models with the self-leveled back suspension bracket increase in system pressure to 0,8 bars. |
|
STATION WAGON AND VAN
| PERFORMANCE ORDER |
| 1. Lift a back part of the car and fix on supports. |
| 2. In the presence, working under a back part of the car, disconnect the air duct of system of the self-leveled back suspension bracket from the shock-absorber. |
|
3. Support by a jack the corresponding lever of a back suspension bracket. Unscrew a nut and remove a washer and a rubber pillow of the lower fastening of the shock-absorber. Lower a jack. |
|
4. Unscrew a bolt (it is specified by an arrow) the top fastening of the shock-absorber and remove the shock-absorber. |
| 5. At installation fix the top part of the shock-absorber by a bolt, having tightened it at this stage by hand. |
| 6. Fix the lower part of the shock-absorber. At the same time check correctness of an arrangement of a rubber pillow and washer and tighten a nut of the lower fastening of the shock-absorber the required moment. |
| 7. Tighten a bolt of the top fastening of the shock-absorber the required moment. |
| 8. Similarly replace the second back shock-absorber. |
| 9. On models with the self-leveled back suspension bracket increase pressure in system to 0,8 bars. |
|
