85425ea0




12:18. Removal and installation of tips of steering draft

Prevention

At removal of a tip of steering draft it is necessary to use a stripper of spherical hinges. At installation it is necessary to use new самоконтрящуюся a nut of fastening of the spherical hinge of a tip of steering draft.

Removal

PERFORMANCE ORDER
1. In the presence take off a wheel cap, then weaken bolts of fastening of a forward wheel.
2. Tighten the emergency brake, then lift a forward part of the car and fix on supports.
3. Remove the corresponding forward wheel.
4. Weaken the bolt clamping a tip of steering thirst for the carving regulator of steering draft.
5. Unscrew самоконтрящуюся the nut fixing the spherical hinge of a tip of steering thirst for a rack of a forward suspension bracket.
6. Using a stripper of spherical hinges, take a pin of the spherical hinge of a tip of steering draft from a rack of a forward suspension bracket.
7. Using paint or an adhesive tape, note an arrangement of a tip of steering draft on the carving regulator. It is also possible to count number of rounds of a carving on the acting part of the carving regulator.
8. Unscrew a tip from steering draft. The tip of the right steering draft is marked by a letter R, and the tip of the left steering draft has no marking.

Installation

PERFORMANCE ORDER
1. Screw a tip of steering draft on the carving regulator in the same situation, as before removal.
2. Establish a pin of the spherical hinge of a tip of steering draft on a rack of a forward suspension bracket and fix new самоконтрящейся by a nut, having tightened it the required moment.
3. Tighten the bolt clamping a tip of steering draft.
4. Establish a wheel and lower the car on the earth.
5. Tighten bolts of fastening of a wheel the required moment.
6. Check and, if necessary, adjust the angles of installation of forward wheels.