85425ea0




12:14. Check of system of the self-leveled back suspension bracket

PERFORMANCE ORDER
1. On completely empty car install the manometer on the air valve and check that pressure in a control system of the self-leveled back suspension bracket makes 0,8 bars. Otherwise adjust pressure.
2. Install the car on the flat horizontal platform and measure distance from the center of a rear bumper to the earth.
3. Subtract 50 mm from the measured distance and write down the received result.
4. Completely load the car and check that the bumper of the car was established at earlier calculated height.
5. If necessary lift pressure in system, but do not exceed it higher than 5 bars.
6. Completely unload the car and reduce pressure in system to 0,8 bars and check that the bumper was established on originally measured height.
7. Do not operate the empty car with high pressure in a control system self-leveled a back suspension bracket.