85425ea0




12:11. Removal and installation of a back beam

Removal

PERFORMANCE ORDER
1. Weaken bolts of fastening of back wheels, then lift a back part of the car and fix on supports.
2. Remove back wheels.
3. On models with system of the self-leveled back suspension bracket take off pressure in system.
4. Disconnect a cable of the emergency brake from the compensator and release it from fastenings on the car bottom.
5. Remove a back part of the exhaust system from rubber pillows.
6. Disconnect a back brake hose from an arm of a back beam and close hoses traffic jams.
7. On the Station wagon and Van models unscrew the bolts fixing an arm of a spring of the valve of adjustment of pressure.
8. Remove springs of a back suspension bracket.
9. Support by a jack through wooden whetstone the central part of a back beam.
10. Disconnect forward fastening (the arrangement of a nut and a bolt is specified by shooters) longitudinal levers of a back suspension bracket from the bottom of the car and lower a jack together with a back beam.
11. Move a cable of the emergency brake on the exhaust system and remove a back beam.
12. At installation of a new back beam rearrange on it elements of the brake system, a nave, the stabilizer of cross stability and other hinged details.

Installation

PERFORMANCE ORDER
1. With the assistant install a back beam on the car, at the same time move a cable of the emergency brake on the exhaust system.
2. Insert bolts of fastening of a back beam, but do not tighten them finally at this stage.
3. Establish springs and fix shock-absorbers.
4. Connect back brake hoses and pump over hydraulic system of brakes.
5. On the Station wagon and Van models, moving an arm, adjust a tension of the spring operating the valve of adjustment of pressure.
6. Fix the exhaust system on rubber pillows.
7. Fix a cable of the emergency brake on the bottom of the car and connect it to the compensator.
8. Adjust bearings of back wheels.
9. Adjust back brakes for what press not less than 10 times a brake pedal, then adjust the emergency brake.
10. Establish wheels, then lower the car on the earth and tighten bolts of fastening of wheels.
11. Load the car, having put on forward sitting of two people, then tighten bolts of fastening of a back beam the required moment.
12. On models with the self-leveled back suspension bracket increase in system pressure to 0,8 bars.