85425ea0




8.1.6.1. Removal and installation of the distributor of ignition

Removal

PERFORMANCE ORDER
1. Mark and disconnect high-voltage wires from spark plugs.
2. Unscrew spark plugs.
3. Unscrew the screws fixing an ignition distributor cover uncover and move it aside.
4. With the released emergency brake and the included transfer close an opening for a candle of the first cylinder a finger and move the car to those forward, you will not feel compression in the first cylinder yet.
5. Move the car further before combination of a tag (it is specified by an arrow) on a pulley of a bent shaft with the index on a cover.
6. At the same time the rotor of the distributor has to be combined with a tag on the ignition distributor case.
7. Disconnect from the ignition distributor the electric socket and a vacuum tube from the vacuum regulator of an advancing of ignition.
8. Unscrew the bolt fixing a tightening level of the distributor of ignition, remove a bolt, a tightening level and the distributor of ignition.

Installation

PERFORMANCE ORDER
1. Check that the adjusting tag on a pulley of a bent shaft is combined with the index.
2. At installation of the distributor of ignition, the shaft of the distributor will slightly turn counterclockwise at connection of gear wheels.
3. After installation check correctness of position of the distributor of ignition, at the same time the rotor of the distributor has to be combined with a tag on the ignition distributor case.
4. Before installation turn an ignition distributor shaft so that the rotor of the distributor was directed to a sealing ring of wires of the distributor of ignition (And – a sealing ring of wires, In – a tag of combination of N1). At installation of the distributor of ignition the rotor will be established in the correct situation.
5. It is also necessary to turn a power shaft of the oil pump in such situation that ledges of a shaft were combined with a groove in an ignition distributor shaft. Turn a shaft so that ledges settled down at an angle 90 ° to an axis of a bent shaft.
6. Check correctness of an arrangement of a sealing ring of round section in the basis of the distributor of ignition and install the ignition distributor into place.
7. For the correct installation of the distributor of ignition, perhaps, it will be required to make this operation several times.
8. After installation of the distributor of ignition into place turn the ignition distributor case clockwise by several degrees so that contacts of the breaker became isolated, then slowly turn it counterclockwise until the beginning of disconnection of contacts.
9. In this position of the distributor of ignition establish a tightening level and fix it by a bolt.
10. Connect the electric socket and a tube of vacuum correction to the ignition distributor.
11. Screw in spark plugs, establish a cover of the distributor of ignition and high-voltage wires.
12. Adjust an ignition advancing corner.