85425ea0




4.2.9. Removal and installation of the oil pallet

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and fix on supports.
2. Merge engine oil in a suitable container and establish a masloslivny stopper into place.
3. Unscrew the bolts fixing a reception exhaust pipe to an inlet collector.
4. Unscrew the bolts fixing a protective plate of a flywheel and remove a plate.
5. Unscrew bolts and remove the oil pallet from the engine.
6. On later models if necessary unscrew a bolt of fastening of an arm of a maslopriyemny tube.
7. Remove a maslootrazhatelny partition and laying. On a part of models rubber laying is used (it is shown in the drawing at the left), and on other models – two pith laying (the drawing on the right).

Installation

PERFORMANCE ORDER
1. If on later models the masloulavlivayushchy plate was removed, clear the interfaced surfaces and establish a plate with new laying or laying. Establish the arm supporting a maslopriyemny pipe, and fix it by a bolt.
2. Clear the oil pallet in kerosene or solvent and remove all external dirt and an internal sediment. Clear the interfaced surfaces of the oil pallet and the block of cylinders of the remains of old laying and check that they pure and dry.
3. Apply a thin film of sealant on the case of the oil pump and the interfaced surfaces of the oil pallet and a back radical cover of the bearing, then establish new laying of the oil pallet.
4. Apply a thin film of sealant on the interfaced surface of the oil pallet and a carving of bolts of fastening of the oil pallet. Install the oil pallet into place and fix by bolts, having tightened them gradually and in the diagonal sequence.
5. Screw a reception exhaust pipe on a final collector. Establish a protective plate of a flywheel and lower the car on the earth. Fill in engine oil in the engine.