85425ea0




11.8. Check, removal and installation of a back brake disk

Check

See subsection 11.7.

Removal and installation

PERFORMANCE ORDER
1. Unscrew two bolts fixing a support of a back brake.
2. Remove a brake support and, using a soft wire, tie up it to a back rack. At the same time do not stretch and do not overwind a brake hose.
3. Release the emergency brake, then remove a protective cap of a nave.
4. Take the forelock fixing a nave nut from unscrewing. Unscrew a nut.
5. Remove a brake disk / nave from the nave fastener.
6. If the brake disk is not removed, through an opening in a brake board take away blocks of the emergency brake from a drum of a brake disk.
7. Installation is made in the sequence, the return to removal taking into account the next moments.
8. At installation of a new brake disk remove a sheeting layer from its surface.
9. Adjust nave bearings / a brake disk.
10. Use the new forelock for fastening of a nut of a nave.
11. Adjust the emergency brake.