11:19. Removal and installation of the lever of the emergency brake


1. Unscrew a nut of fastening of the compensator of cables of the emergency brake and remove the compensator.
2. Remove a rubber protective cover from draft.
3. Remove sitting of the driver for what unscrew bolts of fastening of guides of sitting to a floor.
4. Remove a cap and unscrew the only screw fixing the central console.
5. Remove switches of window regulators and a mirror with the electric drive, then move the central console back.
6. Cut a floor carpet.
7. Unscrew two bolts and remove the lever of the emergency brake.
8. Unscrew the switch of a control lamp of the tightened emergency brake from the lever.
9. If necessary replace a ratchet and the gear sector, but at the same time for removal and installation it is necessary to use them plugs and rivets.


1. Install the lever of the emergency brake into place and fix it by bolts, having tightened them the required moment.
2. Fix a floor carpet by glue or an adhesive tape.
3. Install switches on the central console, then install the console into place and fix it by the screw.
4. Establish forward sitting.
5. Establish a rubber protective cover and the compensator.
6. Adjust the emergency brake.