85425ea0




10.1.5. Removal, installation and adjustment of draft of gear shifting

Removal

PERFORMANCE ORDER
1. Weaken tightening a bolt on the coupling of draft of gear shifting.
2. Unscrew the screws fixing a protective tube of thirst of gear shifting for the car bottom.
3. Shift a rubber cover back and disconnect the intermediate lever from the gear shifting lever basis.
4. Remove a protective cover from the gear shifting lever basis.
5. Remove draft from the car.
6. Remove a rubber cover from a protective pipe.
7. For dismantling of draft beat out a cylindrical pin, the fixing intermediate lever to a core, then beat out a core from the lever.
8. Take a core from a protective pipe.
9. For removal of the universal hinge to a soshlifuyta or drill heads of rivets.
10. At installation it is necessary to use special pins and spring brackets which need to be got before removal of rivets.
11. Plugs can be taken from a protective pipe together with a core.

Installation

PERFORMANCE ORDER
1. Fill with silicone lubricant of a flute in pipe plugs.
2. Fix by a pin new cylindrical the intermediate lever to a core, at the same time their relative positioning has to be such, as shown in the drawing.
3. Establish a rubber cover and a casing, at the same time apply silicone lubricant on their internal surface. Do not move the protection cover after installation.
4. Install draft on the car, combining the intermediate lever with the gear shifting lever, and fix by screws.
5. Establish a rubber cover about the gear shifting lever basis.
6. Adjust draft.

Adjustment

PERFORMANCE ORDER
1. Remove the central console and install the gear shifting lever in neutral situation.
2. Working in a motor compartment, the screw-driver remove a stopper from an adjusting opening (it is specified by an arrow) and weaken tightening a bolt (it is specified by an arrow) on the coupling of draft of gear shifting.
3. Turn the gear shifting rod acting from a cover of the mechanism of the choice of transfers counterclockwise if to look towards a forward part of the car, so, that in the lever of the selector it was possible to insert a shaft of a drill with a diameter of 4,5 mm into adjusting openings and the corresponding openings.
4. Establish draft of gear shifting (with the removed casing).
5. Remove a rubber cover from the basis of the lever of gear shifting and move the lever of transfers in neutral situation to the line of inclusion of the first / second transfer. In this situation adjusting tags (are specified by shooters) on the persistent plug and a casing of the lever of gear shifting have to be combined.
6. While the assistant holds the gear shifting lever, in this situation tighten tightening a bolt of the coupling of draft of gear shifting.
7. Take a drill from an adjusting opening.
8. Check that all transfers join well, then establish a new stopper on adjusting openings.
9. Establish a cover of the lever of gear shifting and the central console.