85425ea0




8.2.6. Removal and installation of the block of ignition (switchboard)

MODELS 1,3 AND 1,4 L WITH THE CARBURETTOR

The control unit of ignition is located in the ignition distributor.

MODELS OF 1,6 L (16 SH) WITH THE CARBURETTOR AND MODELS OF 1,8 L (18 E) WITH SYSTEM OF INJECTION OF FUEL

The control unit of ignition is located on an arm of fastening of the coil of ignition.

PERFORMANCE ORDER
1. For access to the control unit remove the ignition coil.
2. Unscrew screws and remove the control unit from an ignition coil arm.
3. At installation of the new control unit of ignition apply heat-conducting paste on the interfaced surface of the block.
4. Installation of the block of ignition is made in the sequence, the return to removal.
5. At the same time check that adjusting pins of the block accurately were established in ignition coil arm openings.

MODELS OF 1,6 L (16 SV) WITH THE CARBURETTOR AND MODELS OF 1,8 L (18 SE) WITH SYSTEM OF INJECTION OF FUEL

The control unit of ignition is located in a motor compartment about the top fastening of a rack of a forward suspension bracket.
PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Release clamps and disconnect the electric socket from the control unit of ignition.
3. Unscrew screws and remove the control unit of ignition from an arm.
4. Installation is made in the sequence, the return to removal.

MODELS 1,4 AND 1,6 L WITH SYSTEM OF INJECTION OF FUEL AND ALL MODELS OF 2,0 L

See subsection 6.2.11 and subsection 6.2.12.2.