85425ea0




4.3.11.1. Removal and installation

Removal

PERFORMANCE ORDER
1. Take off a gear belt.
2. Disconnect pipelines of the oil heater from a casing of the filter and move them aside.
3. Uncover heads of the block of cylinders and pulleys of camshafts.
4. Remove the mechanism of a tension of a gear belt and the directing rollers.
5. Unscrew a bolt of fastening of a pulley of a bent shaft. For keeping of a bent shaft from a provorachivaniye include any transfer and press a brake.
6. Using a stripper, remove a pulley of a bent shaft. Remove the laying located behind a pulley and a back casing of a gear belt.
7. Remove the oil pallet, a maslozaborny pipe and a maslootrazhayushchy plate.
8. Unscrew bolts and remove the oil pump from the block of cylinders. Clear the interfaced surfaces of the oil pump and the block of cylinders.

Installation

PERFORMANCE ORDER
1. Apply a thin film of lubricant on laying and install it on the oil pump. Grease working edges of a sealing ring with pure engine oil and, being careful, install the oil pump on the block of cylinders of the engine.
2. Screw in bolts of fastening of the oil pump, then move the oil pump so that the lower surface of the pump was flush with the lower surface of the block of cylinders, and tighten bolts of fastening of the oil pump the required moment.
3. Apply a thin film of GM 15 04 200/8 983 368 sealant on the external surface of laying and move laying to a bent shaft.
4. Further installation is made in the sequence, the return to removal. Remember that at installation it is necessary to use a new gear belt.