| 1. Installation is made in the sequence, the return to removal taking into account the next moments. |
| 2. If at removal from the hydrotransformer transmission liquid flowed out, fill in it to norm. |
| |
3. Wipe the hydrotransformer plug that at installation not to damage a sealing ring of an entrance shaft of the transmission, and check that the hydrotransformer was correctly combined with a pump shaft. For this purpose measure distance And which has to make 9,0–10,0 mm. |
| 4. Otherwise turn and press the hydrotransformer for its combination with a pump shaft. |
| 5. Apply a small amount of lubricant on the basis of a molybdenum disulfide on the directing plug of the hydrotransformer and the corresponding dredging in an end face of a bent shaft. |
| 6. Combine a color tag on the hydrotransformer with a white tag on a plate of the drive and fix the hydrotransformer by bolts. Keep in mind that bolts of fastening of the hydrotransformer are not tightened yet, between the hydrotransformer and a plate of the drive there will be a gap equal to 0,4-1,5 mm. |
| 7. Gradually and consistently tighten bolts of fastening of the hydrotransformer. |
| 8. On the transmissions with the EF and EC codes intended for work without oil heater do not remove a cap from couplings of connection of pipelines of the oil heater. |
| 9. Adjust a cable of the choice of transfers and a cable of compulsory inclusion of a low gear. |
| 10. Fill in transmission liquid in the transmission. |
