Opel:: Kadett E:: Removal, installation and adjustment of a cable of the choice of transfers

10.2.3. Removal, installation and adjustment of a cable of the choice of transfers

Elements of fastening of a cable to the selector lever

And – a clip,

In – the plug

Removal

PERFORMANCE ORDER

1. Remove a weight wire from the accumulator.
2. Release the selector lever for what unscrew and move the central console back, then disconnect decorative finishing from the central console and the lever of the selector.
3. Remove the holder of a bulb.
4. Disconnect a cable and a cover of a cable from the selector lever.
5. Remove a lock ring and disconnect a cable from the transmission.
	6. Take a cable cover from an arm (And – a bracket of fastening of a cable, In – an arm of fastening of a cover of a cable).
7. In interior of the car tie a thin long cord which will be required for installation of a cable into place to the end of a cable.
8. Take a cable in a motor compartment and untie from it a cord, having left it on the place.

Installation and adjustment

PERFORMANCE ORDER

1. At installation of a new cable install the lever of the choice of transfers on the transmission and the selector lever in situation P.

2. Establish a cable so that it was not strongly tense, but at the same time and did not sag.

3. Check that the lever of the selector moves to all provisions and at the same time the lever of the choice of transfers on the transmission is combined with the corresponding clamp.

4. If necessary adjust cable length from the central console.

5. Further installation is made in the sequence, the return to removal.