85425ea0




1.14. Adjustment of height of a back suspension bracket

Adjustment of height of a back suspension bracket provides an opportunity at various level of load of the car behind including when driving with the trailer to support height approximately at the constant level and considerably improves passability of the car.

Manual adjustment is made by means of the automobile pump or the compressor. The nipple of the pumping-up device is on the right side of the luggage compartment.

At full loading for reasons of safety it is forbidden to go by the maximum excessive pressure.

At full load of the car pressure in the device has to correspond to the minimum value of 300 kPa (3 bars). Pressure should not be below basic value of 80 kPa (0,8 bars) at all. Pressure needs to be controlled periodically.

PERFORMANCE ORDER
1. Install not loaded car on the flat horizontal platform. Fill the device with pressure of 80 kPa (0,8 bars). Measure height of a rear bumper over earth level, subtract 5 cm from the received value and write down it.
2. If when loading the car this size becomes less, increase pressure before achievement of former value. Do not lift pressure above a mark of 500 kPa (5 bars).
3. Before a trip on not loaded car surely reduce pressure to 80 kPa (0,8 bars).