1.11. Body elementsFixing of doors
|From within: press a clamp. The pressed clamp on an open door at its closing jumps out up (protection from blocking). If when closing a door the handle is wrung out, the clamp does not jump out up.
|Central blocking of doors, trunk lids, covers of the fuel tank.
Blocking: turn a key (in the lock of forward doors or trunk lids) or press a clamp (on the driver's door).
Unblocking: turn a key (in the lock of forward doors or trunk lids) or extend a clamp up (on one of forward doors).
The pressed clamp of an open door of the driver when closing jumps out up: all doors will be unblocked (protection from blocking). If when closing the handle of a door is wrung out, the clamp does not jump out up.
The recorded doors will be unblocked at accident independently (for assistance outside), a condition – it is impossible to switch off ignition.
At electronic control by windows closing of windows outside is possible: hold a key in the provision of closing of a door until windows are not closed.
If it is required to open a back door along with the driver's door, it is necessary that the groove was installed in the cylinder of the lock of a back door in horizontal position. If the groove is put in vertical position, the lock of a back door will not open.
At an overload due to frequent inclusions through short periods power supply will be interrupted approximately on 30 pages.
Blocking for children
|Move the lever on the lock of a back door down: now the door cannot be opened from within. The door can be opened only outside if the clamp is not pressed.
It is blocked: at vertical position a vent in the lock.
It is unblocked: at horizontal position a vent in the lock.
The lock opens by pressing its head.
|Pull the unblocking handle under the dashboard from the driver. The cowl of the engine will be unblocked and will open with formation of a crack. Return the handle to a starting position.
Approximately at palm width distance to the left of the center of a cowl – if to look in front – on the lower surface of a cowl there is a safety capture: pull for it and open a cowl.
|To enshrine a cowl in the open provision, insert located over a support cooler lattice in narrow longitudinal vents on the lower surface of a cowl.
Before closing of a cowl strongly press support in their holders.
Release a cowl before its lowering in the lock.
Check fixing of a cowl, having pulled for its forward edge. If the cowl is not recorded, repeat the previous operation.