9.2. Coupling cable
Prevention
In 1989 a part of cars were manufactured with height of installation of a pedal of a brake of coupling 15 mm higher than a pedal. Normal installation of a pedal of a brake is 4 mm lower than a coupling pedal. If necessary adjust height of installation of a pedal of a brake for what change length of a pusher of the vacuum amplifier of brakes, rotating a fork on a pusher.
| PERFORMANCE ORDER |
| 1. When replacing coupling or a cable of coupling it is necessary to make initial adjustment of a cable of coupling. |
|
2. Using a roulette, measure distance And from the center of a rubber overlay of a pedal of coupling to a steering wheel in a starting position of a pedal of coupling and write down the measured value. |
|
3. Press a coupling pedal against the stop and take similar measurement (distance In). |
| 4. Define the coupling pedal course for what subtract the first measurement from the second. The course of a pedal of coupling has to conform to technical requirements. |
| 5. Otherwise adjust coupling cable length as follows. |
|
6. In a motor compartment remove the bracket fixing a carving tip of a cable of coupling to the squeezing lever and rotating the regulator, adjust a coupling cable. Rotation of the regulator clockwise increases the pedal course, and counterclockwise – reduces it. |
| 7. Perform repeated measurement of the course of a pedal and establish the bracket fixing a carving tip of a cable of coupling. |
| 8. If coupling is operated a long time, perhaps, adjustment of a cable of coupling will not yield result. It testifies to wear of frictional overlays of a clutch plate and need of replacement of a clutch plate. |
|
