| 1. Measure length of a carving tip of a cable of coupling acting from the squeezing lever in a motor compartment. This size needs to be used for ensuring the correct installation of a cable of coupling. |
| 2. Remove the bracket fixing a carving tip of a cable of coupling to the squeezing lever and remove a carving tip from the lever. For simplification of removal move the lever to the engine. |
| 3. Remove fastening of a cover of a cable of coupling from ledges on a coupling case. |
|
4. In interior of the car remove the lower panel of finishing in deepening for the driver's legs, then disconnect a returnable spring from a pedal of coupling and remove a coupling cable from a coupling pedal. Keep in mind that the returnable spring also fixes to a coupling pedal a coupling cable (And – the place of fastening of a cable of coupling by a returnable spring). |
| 5. For improvement of access it is recommended to remove a coupling pedal. |
| 6. Through a partition of a motor compartment take a coupling cable in a motor compartment. At the same time do not damage a sealing ring of a partition of a motor compartment. |
| 7. Installation is made in the sequence, the return to removal. |
| 8. Establish a carving tip of a cable of coupling so that its vystupaniye from the squeezing lever was same, as well as before removal. |
| 9. Check correctness of an arrangement of a sealing ring in a partition of a motor compartment. |
