5.2. Removal and installation of hoses of the cooling system
Check a condition of hoses of the cooling system and with defects replace a hose as follows.
| PERFORMANCE ORDER |
| 1. Merge cooling liquid from the cooling system. If cooling liquid does not be replaced, it can be reused. For this purpose bring together her in a pure container. |
| 2. An edge of the screw-driver weaken collars and move them on a hose. Being careful, remove a hose. If the hose sits very densely, having pulled, turn it on a branch pipe. |
| 3. Keep in mind that radiator branch pipes very fragile therefore at removal of hoses do not make excessive effort. If the hose is not removed from a branch pipe, cut off a hose, and cut the part of a hose which remained on a branch pipe on two half. At the same time it is necessary to use a new hose. |
| 4. At installation of a hose, previously put on it collars, then establish a hose into place. |
| 5. For fastening of a hose it is desirable to use collars with the screw. If rigid and it it is difficult to establish a hose into place, moisten the end of a hose with soap water or soften it in hot water. |
| 6. Check that the hose is correctly located, then fix the ends of a hose by collars. |
| 7. Fill in cooling liquid in the cooling system. |
| 8. Check tightness of the cooling system. |
|
