| 1. Remove a power shaft. |
|
2. Remove collars (are specified by shooters) fastenings of a protective cover of a power shaft and shift a rubber protective cover on a power shaft. |
|
3. Using flat-nose pliers or screw-drivers, expand a lock ring (it is specified by an arrow), which fixes the hinge of a power shaft to a power shaft. |
|
4. Using the rubber hammer or a kiyanka, bring down the hinge from a power shaft. |
| 5. Shift a protective cover from a power shaft. |
| 6. Clean old lubricant from the hinge of equal angular speeds. |
| 7. Establish a new protective cover on a power shaft so that the flange of a protective cover was established in flutes of a power shaft. |
| 8. Install the hinge of equal angular speeds with a new lock ring on a power shaft. At the same time the lock ring has to be recorded accurately in a flute of a power shaft. |
| 9. Fill the hinge of equal angular speeds with lubricant. |
| 10. Install a protective cover on the hinge of equal angular speeds, then let out the air from under a protective cover. |
| 11. Install a power shaft on the car. |
